DAVID GODFREY'S CAMBER ADJUSTERS

 
David has designed a set of eccentric camber adjusters for the Merkur XR4Ti.  Below are some photos showing these adjusters.  The ones with the radius go on the rear of the cross member.

Camber Adjusters - 2 Types

TWO TYPES OF CAMBER ADJUSTERS

 

Camber Adjuster - Front (decreased position)

FRONT ADJUSTER IN DECREASED CAMBER POSITION

 

Camber Adjuster - Front (stock position)

FRONT ADJUSTER IN STOCK CAMBER POSITION

 

Camber Adjust - Rear (decreased position)

REAR ADJUSTER IN DECREASED CAMBER POSITION

 

Camber Adjuster - Rear (stock position)

REAR ADJUSTER IN STOCK CAMBER POSITION
 

Design changes have already been implemented on the the rear eccentrics.  They are now tapped with a M12 x 1.5 thread. This reduces the length of the bolt and gets rid of a nut.  These parts allow adjusting camber for fine tuning suspension geometry.

 

For more information, send David an e-mail at  DGodfrey@DRS-TEM.com .

Back to David Godfrey's Page                                                           Back to Site Home Page

MORE POWER!

THE ULTIMATE SOURCE OF POWER